when I give "Change Instruction" shows this messagebox "unknown Command"
for example typing "je", "jne","jmp"..., the only correct instruction is "nop"
how to use debugger ?
Works fine for me. Just key-in instructions in the disassembler window, using the same syntax as how the instructions are shown by the disassembler.
For "je/jne/jmp" you would also need to type parameters, eg. "jmp 0bfc00000", or "j bfc00000" if you've selected to alternate/native asm syntax in debug/setup.
For "je/jne/jmp" you would also need to type parameters, eg. "jmp 0bfc00000", or "j bfc00000" if you've selected to alternate/native asm syntax in debug/setup.
Who is online
Users browsing this forum: No registered users and 4 guests