Hello guys Before leaving my question here, I must inform you that this is the first post I create in this amazing community, so it's not the wrong peak, I apologize for the mistake and that if possible, go to the correct place. Thanks. I'm being used in programming with C and one of my goals is to ...

I did a better reading of the post and I think I found your current problem: reader wear. When moving the potentiometer of the reader, you reduced the voltage sent to the lens and because of that it is no longer able to read properly, so it is crashing on the PS screen sometimes. when it reads the d...

reply for TEddy69 Everything indicates that it is a problem with the optical set of the device, if you want to confirm do the following, connect only the white wire of the reader to the board, turn on the device, press the button that turns the reader on and see if it turns off, if it stays making n...

did you check the resistance on the power button terminals with it pressed? if you don't resist, it's ok. these components are fuses, and one of them in specific is jumpered with a thin copper wire, it is the PS004, if I'm not mistaken it is responsible for feeding the controls with 3V or 8V I don't...

I had this problem on one of my psones. in my case it was a problem with the power button, it was acting as a resistor limiting the voltage and current coming out of the button. in that case, it would be necessary to replace it or do the easiest thing, dismantle it, clean it with isopropyl alcohol a...