Anyway, good job guys!

Ok it works, the ATtiny45 I used was broken somewhere. Thank you for your help guys!
I stuck on the point: Code should have .h for modifying parameters and adding hysteresis parameters in it too.
And.. goto in C in 2018? =))
Cheers

rama3 wrote: October 25th, 2018, 11:49 pm Do you have very long wires anywhere by chance?
The only long wire in the whole debug setup should be the USB one, as USB is buffered.

Also, what are you fuse settings? The oscillator may be in 1Mhz mode.

Nope, 5cm 30gauge wires

Add this line to see what is your F_CPU define.
DEBUG_PRINT(F_CPU);
If you have a discrepancy between chip / pc baud rate (it's exactly 8x times in your case), F_CPU define and oscillator mode might be different, make sure it's all the same (8MHz internal oscillator and F_CPU is 8000000).


I ...

Ok.. by using mySerial.begin at 9600 instead of 115200 AND monitoring at 1200, I have my "START" debug print
the result:

START
m 0
340A88880AC0900AA1183C01
202804113C81001822010420
001080108E402C01200AC6C0
00A24202DAA880CA86180E00
906CA4058760041CC6101D07
34D8400E86504CC6E4130CC1 ...

(with #define PSNEEDEBUG and #define USINGSOFTWARESERIAL)

I tryed with 4 softwares, all give me the same not correct symbols like the baudrate is wrong.
The wires are like this:

USB TTL TX -> ATtiny pin 2 (PD3)
USB TTL GND -> ATtiny pin 4 (GND)

Maybe I'm doomed...
When I monitor the pin 2 (PB3) of the Tiny45, I can't get correct values from psnee baudrate (115200 or 500000)

Yes, it can be automatic but just for debugging I suggest to force it. You can debug on ATtiny 45 by using physical IC pin 2. 84 is supported only in my branch for now.

EDIT: you can also try reducing hysteresis level to 10 and 7 respectively, maybe that will help:

if (hysteresis >= 14 ...

Hi superg, thanks for your reply.
It says PSnee 7 is automatic for multiRegion right? If I read I can see only the PSone have to set the region?
Is debug via serial possible on ATtiny45/84?

Hello everyone.
I can't get PSnee working, I explain my problem:

-I use ATtiny45 with internal 8mHz clock programmed via Arduino UNO as ISP
-In the code, I use only #define ATTINY_X5
-Wires are perfectly like the README on GitHub
-IC is decoupled with 100nF capacitor (tryed with and without, but I ...