BIOS installation concerns No$PSX

Problems or feedback about the NO$PSX emulator by Martin Korth
Post Reply
Tyson1911
What is PSXDEV?
What is PSXDEV?
Posts: 3
Joined: Jan 31, 2021

BIOS installation concerns No$PSX

Post by Tyson1911 » January 31st, 2021, 12:34 pm

Hello everyone and been reading lately that this bios is quite complete and interesting so I was encouraged to sacrifice one of my PS1, the problem is that while I was removing the old bios it broke my. I tried to install the new bios and this one does not turn on I use a SST39VF040 with an adapter that I send to manufacture. the pins match and only without connecting the WE pin.

My query that I could have done wrong so that it did not turn on the console?.

The board is not making bad contact with any pin, there is also no continuity between pins
20210130_221202_copy_2016x980.jpg
Thank you very much for your help and time, greetings
You do not have the required permissions to view the files attached to this post.

danhans42
BANNED
BANNED
Posts: 329
Joined: Nov 28, 2012

Post by danhans42 » February 5th, 2021, 3:06 am

If WE is floating that can cause you issues. Have you tied it high through a resistor?
That's the only thing I can think of if you are certain the connections are correct.

Tyson1911
What is PSXDEV?
What is PSXDEV?
Posts: 3
Joined: Jan 31, 2021

Post by Tyson1911 » March 16th, 2021, 10:12 pm

What resistance value should I install, pin WE is direct to VCC 3.3v, practically followed the same pins except pin A19 which is not present on the chip

danhans42
BANNED
BANNED
Posts: 329
Joined: Nov 28, 2012

Post by danhans42 » March 24th, 2021, 7:50 pm

4.7kohm resistor should go just fine.

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests