how to use debugger ?

Problems or feedback about the NO$PSX emulator by Martin Korth
Post Reply
pepe
Curious PSXDEV User
Curious PSXDEV User
Posts: 28
Joined: March 26th, 2015, 1:22 am

how to use debugger ?

Post by pepe » October 19th, 2017, 3:03 am

when I give "Change Instruction" shows this messagebox "unknown Command"
for example typing "je", "jne","jmp"..., the only correct instruction is "nop"

User avatar
nocash
PSX Aficionado
PSX Aficionado
Posts: 306
Joined: November 12th, 2012, 2:36 pm
Contact:

Re: how to use debugger ?

Post by nocash » October 22nd, 2017, 8:32 pm

Works fine for me. Just key-in instructions in the disassembler window, using the same syntax as how the instructions are shown by the disassembler.
For "je/jne/jmp" you would also need to type parameters, eg. "jmp 0bfc00000", or "j bfc00000" if you've selected to alternate/native asm syntax in debug/setup.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests