SCPH-1001 PU-8 MM3 Stealth Mod Chip Installation

General information to do with the PlayStation 1 Hardware. Including modchips, pinouts, rare or obscure development equipment, etc.
Post Reply
Haldrie
What is PSXDEV?
What is PSXDEV?
Posts: 3
Joined: March 31st, 2019, 6:52 am

SCPH-1001 PU-8 MM3 Stealth Mod Chip Installation

Post by Haldrie » March 31st, 2019, 7:29 am

I am going to come out and say that I did not come up with this but I can't find the original post I found the diagram I used so I made a new one using a picture I took of my own MM3 stealth installation. I am posting this to debunk the claim that you cannot install a MM3 with Stealth on a SCPH-1001 PU-8 motherboard as anyone can follow this diagram and see that stealth should work as it does for me. For anyone who finds this useful you are very welcome. If anyone has any questions about this feel free to ask though my knowledge is limited to mostly just following diagrams and what little I read in forums like this one. My install has the chip in a 8-pin DIP socket on the other side of the board for each access so I can swap out chips for testing or just replacing if something goes wrong with the chip itself. I originally did this using a 12F629 chip but replaced it with a 12C508A chip so I could use the other one for something else and I had a ton of 12C508As that I finally learned how to flash correctly (yes I flash my own chips). Again the attached diagram I made myself just so I could post it here to be helpful to anyone looking to install a MM3 mod chip and get Stealth on their SCPH-100x PS1 as I saw another post where someone told them it wasn't possible. Oh and as for the diagram going around showing another 7 wire installation for this board I also tried it and it only functioned as a 4 wire install with no stealth though you can see my pin 4 wire is in a different place then that one if you have seen it and the pin 7 wire is located on another point which happens to lead to the same spot as that other diagram but is closer to the side of the board I folded the chip over on to so my wire can be just that much shorter.

Image

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests