[Diagram]SCPH-1000/3000 PU-7 MM3 Stealth Install

General information to do with the PlayStation 1 Hardware. Including modchips, pinouts, rare or obscure development equipment, etc.
User avatar
TriMesh
PSX Aptitude
PSX Aptitude
Posts: 225
Joined: Dec 20, 2013
PlayStation Model: DTL-H1202
Location: Hong Kong

Post by TriMesh » July 29th, 2017, 11:12 am

TheShadowRunner wrote:
TriMesh wrote:The other difference is that the SCPH-xxx3 models use the same 7.5IRE black level that NTSC:U/C consoles do, rather than the 0IRE level used in Japan.
I never understood the impact of the different IRE levels when it comes to consoles. For instance if a JPN system and US system were connected to the same monitor via RGB, JPN would have a darker image? Or does it only affect the composite signal?
In theory, it only applies to composite and Y/C - in practice, given the way it's implemented on the PSX, it also shifts the DC level of the RGB outputs too. But you may not see any visible effect from this depending on your monitor, since it's also outputting the same elevated black level during the horizontal blanking interval which is normally where the monitor establishes the black level.

Note that this is different from the US style NTSC signal - in that, the reference level during the blanking interval is still 0IRE and the 7.5IRE setup is only present during active line time.

User avatar
ady05113
Curious PSXDEV User
Curious PSXDEV User
Posts: 31
Joined: Dec 27, 2014

Post by ady05113 » October 14th, 2017, 2:25 am

Traace wrote:Hi Community, It started when I bought a SCPH-3000 from eBay. Because these Japanese Systems are not that common here in the EU.

I just fell in love with the PU-7 Boards.
Not only the SCPH-1000 runs with a PU-7 Mainboard, also the SCPH-3000 does, they just removed the S-Video.

There was zero information on the net about the rare PU-7 Mainboards, so i traced the board with the help of some schematics. Counting pins on a 80-pin HC05 QFP isn't that easy.

And here I'm now, done and exhausted, but at least we got a hi-res diagram with Stealth support now for all the dirty PU-7 Mainboards out there.

(Click on the pic)
Image


PS1 is love :praise

2x SCPH-3000 were tested now, its worth to note that these Systems don't suffer from FMV Lag at all! Even with the Stock Laser Lens.

I also managed to place in a 230V EU(PAL) PSU into the Japanese SCPH-3000. If someone need that diagram, just let me know :)
Thanks for sharing its working with my PU-7. Actually i have two PU-7 motherboards. But another one is not working with stealth mode. I tried to play Dance Dance Revolution and it get stuck it get detected as modified system screen. Anyway the motherboard model number is 1-655-322-11. I guess this is the earlier version of PU-7 motherboard.

If you know how to make this motherboard stealth please share here. :D

rama3
/// PSXDEV | ELITE ///
/// PSXDEV | ELITE ///
Posts: 510
Joined: Apr 16, 2017

Post by rama3 » October 14th, 2017, 3:11 am

No old style modchip code has stealth support for PU-7 but you can use PsNee:
http://www.psxdev.net/forum/viewtopic.p ... 120#p12683

SDenis
What is PSXDEV?
What is PSXDEV?
Posts: 1
Joined: Mar 11, 2018

Post by SDenis » March 11th, 2018, 2:43 pm

Hi!:) I need help: I have psone 102 with 12c509a chip on it and is there any chances, that chip will work on SCPH1000 PU7?
ABBC3_SPOILER_SHOW

chip127
What is PSXDEV?
What is PSXDEV?
Posts: 2
Joined: Mar 24, 2018

Post by chip127 » March 24th, 2018, 11:05 am

Traace wrote: May 3rd, 2017, 12:35 am
PS1 is love :praise

I also managed to place in a 230V EU(PAL) PSU into the Japanese SCPH-3000. If someone need that diagram, just let me know :)
Help. Give please the diagram. :shrug

User avatar
Traace
Curious PSXDEV User
Curious PSXDEV User
Posts: 12
Joined: Mar 07, 2016

Post by Traace » July 26th, 2021, 12:17 am

Push after few years.

btw: I'm still around :) | Germans would say: "bad people are always fine"
Gaming Devices (Sony only):
PS1: 1xSCPH-7502 (Still unmodded)
PS2: 1xSCPH-70002 (FMCB)
PS3: 1xCECHG04 4.81.2 Rebug CFW

Post Reply

Who is online

Users browsing this forum: No registered users and 10 guests