Psone Power jack plug size ?

General information to do with the PlayStation 1 Hardware. Including modchips, pinouts, rare or obscure development equipment, etc.
Post Reply
adamp2006
What is PSXDEV?
What is PSXDEV?
Posts: 2
Joined: Nov 19, 2016

Psone Power jack plug size ?

Post by adamp2006 » November 24th, 2016, 5:18 am

Just found that the power plug for my PSOne has been run over by an office chair and so was wondering what size it used to be as a standard 5.5mm doesnt fit , anyone have an idea on what size its meant to be so i can get a replacement end for a quid instead of forking out £10+ for the whole plug ?
Top
User avatar
Shadow
Verified
Admin / PSXDEV
Admin / PSXDEV
Posts: 2670
Joined: Dec 31, 2012
PlayStation Model: H2000/5502
Discord: Shadow^PSXDEV

Post by Shadow » November 28th, 2016, 2:27 am

Outside diameter: 4.75mm (0.185").
Inside diameter: 1.25mm (0.050").

Center positive at 7.5 Volts and 2 Amps.
Development Console: SCPH-5502 with 8MB RAM, MM3 Modchip, PAL 60 Colour Modification (for NTSC), PSIO Switch Board, DB-9 breakout headers for both RGB and Serial output and an Xplorer with CAETLA 0.34.

PlayStation Development PC: Windows 98 SE, Pentium 3 at 400MHz, 128MB SDRAM, DTL-H2000, DTL-H2010, DTL-H201A, DTL-S2020 (with 4GB SCSI-2 HDD), 21" Sony G420, CD-R burner, 3.25" and 5.25" Floppy Diskette Drives, ZIP 100 Diskette Drive and an IBM Model M keyboard.
Top
adamp2006
What is PSXDEV?
What is PSXDEV?
Posts: 2
Joined: Nov 19, 2016

Post by adamp2006 » December 16th, 2016, 2:17 am

Thanks for the information, only just seen that there was a reply, ended up getting a 4mm x 1.7mm and it fits ok but be good to get hold of the right size as the one i have is a little on the tight size for the inner part but its doing the job.

Thanks again for the info :)
Top
Post Reply

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 10 guests