Question about DFO mod…
Posted: April 9th, 2022, 12:17 pm
Hi all,
Installed a DFO mod on a 7002 Pu-20 revision.
Everything seems fine, testing with an OSSC, it’s reporting the correct frequencies.
Just a quick one, in the photo, can the highlighted points be bridged by solder? I think they are okay to be, I tried to avoid it but am now fretting they are, but can’t find a high quality enough picture of a standard board to figure it out.
Any help would be grand. I don’t think I bridged them but would like to know if it’s okay if I did.
Thanks.
Installed a DFO mod on a 7002 Pu-20 revision.
Everything seems fine, testing with an OSSC, it’s reporting the correct frequencies.
Just a quick one, in the photo, can the highlighted points be bridged by solder? I think they are okay to be, I tried to avoid it but am now fretting they are, but can’t find a high quality enough picture of a standard board to figure it out.
Any help would be grand. I don’t think I bridged them but would like to know if it’s okay if I did.
Thanks.