PlayStation Development Network

Hello,

anyone knows the Pinout for the Controller Board DTL-2500?
Greeting black2000

I imagine that the H2500 may have the same ports as the H2000 and if so, you can use the pinouts on Shadow's DTL-H2000 thread topic. I'm not entirely sure though since I haven't seen an H2500 before so you'll have to wait for Shadow's advice.

Hi LameBoy 64,

H2500 has only one COM port.
A connector on the board with10 pinout for Flatcable.

It's been a while, and I've never owned or used the 2500, but from what I can remember, the controller pinouts were mounted on a separate PCB and ribbon cable that then could be screwed to your PC chassis like a standard card faceplate. So you're actually missing a part of the kit, and you'll need to manually re-create it.

If you do a few Google searches, you'll eventually end up at [ASSEMbler Games Forums], and there should be plenty of information for you there.